01033504 WCN3660_BT 4.0 Auto test question

[admin]

Subject

WCN3660_BT 4.0 Auto test question



Description

We want to set up BT4.0 automated testing.
Instrument is Agilent N4010A.
BT 4.0 tool name is "AgN4010BT4_ATE" from agilent.
However,BT4.0 can not recognize the com port,but BT 3.0 is normal (tool is "virtual front panel").
error information : COM57 Opened
COM57 dutStopTx() Failed !
COM57 Closed.
So we want to check BT4.0 testing environment settings (another com port? HCI? Baud rate? or...).

Thanks for your help
BRs
Alan

[admin]

Comment



Created By: David Lan (12/11/2012 5:02 PM)
Dear Timothy,

Sure, no problem.
We had submitted another SR01045993 for this question already.

Yours Sincerely,
David




Created By: Timothy Liu (12/11/2012 10:24 AM)
Dear customer,

Please feel free to file seperate software BT cases for the HCI command questions, so that our BT software expert may help to comment.

Thanks
Timothy




Created By: David Lan (12/10/2012 11:31 PM)
Hi Rossi,
Thank you for your kind help.
We can test the WCN3660 BLE manually.
By the way, do you happenn to know that whether your ftmdaemon service can deal with RealTerminal HCI command directly or not.
As we know, it supposed to send MUT the HCI command via UART raw data.
Sincerely,
David




Created By: Rossi Hung (11/27/2012 6:36 AM)
Hi Alan,

At the first step before you start to run any automation test, can you double confirm if you can test the WCN3660 BLE manually or not?

For the DUT side (WCN3660) BT4.0 testing environment setting, it only requires to configure the DUT into FTM mode and trigger BLE TX only or BLE RX only burst.

Please check with dutStopTx() failure with Agilent team as it looks not the Qualcomm FTM API.

Regards,
Rossi.